Frequency
Type of code
- Fixed. The code emitted by the remote control, is always the same. There is no encryption and once the remote control is duplicated, the copy works directly in the receiver.
- Rolling. The code emitted by the remote control, changes with each pulse. A copy of the remote control should be made, that way generating the same brand and model but with a different serial number, that will be necessary for registry in the receiver. There are specific instructions for each receiver of either how to register the copy, remotely or directly manipulating the receiver.
Buttons
Auto-Programmable The remote control can be registered in the receiver without the need of the original remote control, as long as radio communication is activated and the memory is not full.
PROCESS:
- In front of the receiver keep the JMA remote control pressed during 10 seconds until the red LED goes off (after 4 seconds) and it turns to green (at 10 seconds).
- Once the LED is green, release the button and wait for the LED to definitely go off. During the process, the green LED will flash once or several times depending on the code type until finally going off.
If the process does not work, test the standard method using the original remote control or gaining access directly from the receiver.
Copy
No copy
DTM SYSTEM® NE0 Remote
- F 433,92MHz
- C ROLLING CODE
- B 2,4
- AP YES
- M-BT Biometric / BT Slim / M-NOVA PRO / M-BT Advance
HOW TO SYNCHRONISE DTM NEO SPACE ROLLING CODE REMOTE CONTROLS
DTM NEO remote control synchronisation can be performed either directly on the receiver itself or remotely using a remote control that is already synchronised with the receiver.
Remotely synchronising the remote control on the receiver
1. While holding the receiver’s button, press a button in the remote which you want to register. The light will blink.
While registering the remote in the receiver’s memory, the button controlling the output channel must be used. Only one button of the remote can be registered. Registering another button of the same remote will result in removing the previous one.
Synchronising the remote control directly on the receiver
1. press and hold button in previously registered remote for 15 seconds,
2. press and hold button in a remote which you want to register for 15 seconds, within 3 seconds after releasing the previous button,
3. the new remote is now registered with the same active button as in the previously registered remote.
