HOW TO SYNCHRONISE ELVOX ROLLING CODE REMOTE CONTROLS

ELVOX remote control synchronisation can only be performed directly on the receiver itself.

Synchronising the remote control directly on the receiver

Sliding and hinged doors

1. Hold the button on the receiver I2(P2).

2. While still holding the button on the receiver, press the button on the remote control to be synchronised.

3. Wait for the LED to flash, confirming the synchronisation.

4. Release both buttons.

ECRU receiver

1. Hold the button on the P1 receiver for two seconds. The DL1 LED will flash green.

2. Release the P1 button on the receiver.

3. Press button 1 on the remote control to be programmed.

4. The blue DL5 LED will flash.

5. On pressing the P1 button again for two seconds, the DL2 LED will flash green to synchronise channel 2.

6. Press button 2 on the remote control to be programmed.

7. The blue DL5 LED will flash.

8. To synchronise buttons 3 and 4, repeat steps 5 to 7. The LEDs DL3 and DL4 will light. Press buttons 3 and 4 in each case.

9. To leave synchronisation mode, press buttons P1 and P2 when the green LED flashes while waiting for a signal.