DAR DE ALTA MANDOS EVOLUTIVOS DEA

SYNCHRONISING DEA ROLLING CODE REMOTE CONTROLS

DEA receivers can work in fixed or rolling code mode. These modes can be selected by placing a jumper in certain positions. The jumper is located in the centre of the circuit board and the positions are marked A (fixed position) and B (rolling code mode).

In rolling code mode, DEA remote controls can be synchronised either remotely or directly on the receiver.

Remote synchronising procedure

1. Stand near the receiver and simultaneously press the two buttons of the device already synchronised in the facility.

The LED on the receiver will light up steady, indicating that it has switched to synchronisation mode.

2. Within 5 seconds, press the button of the device to be synchronised.

The receiver LED will flash and then turn off, indicating that device has been successfully synchronised.

Direct synchronisation procedure on the receiver

1. Open the receiver and press and release the P1 pushbutton located to the right of the circuit board, below a LED.

The LED will light up, indicating that the receiver has entered synchronisation mode.

Be sure to release the P1 button as soon as the LED lights up. If the button is held down until the LED turns off, it will delete the contents of the receiver\'s memory.

2. Press the left button of the device to be synchronised.

The receiver LED will flash once, indicating that device has been successfully synchronised.

3. Synchronisation has been successfully performed. Repeat step 2 for each additional remote control you wish to synchronise. Otherwise, wait until the LED turns off after storing the code and the receiver exits synchronisation mode.

Observations

If the procedure fails, it may mean that the receiver memory is full and impedes synchronisation of new devices. In this case only the installer will be able to synchronise any new remote controls.