SYNCHRONISING DOORMATIC ROLLING CODE REMOTE CONTROLS

In rolling code mode, DOORMATIC receivers can be synchronised either remotely or directly on the receiver.

Remote synchronising procedure

1. Stand near the receiver and press and release the button on the front of the remote control already synchronised in the facility. This button is located under the coloured casing.

The receiver will emit a beep, indicating that it has switched to synchronisation mode.

2. Within 5 seconds, press the button of the device to be synchronised.

The receiver will emit two beeps, indicating that the code has been stored.

Wait for 30 seconds until the receiver emits two beeps, indicating that it has exited the synchronisation mode.

Direct synchronisation procedure on the receiver

1. Open the receiver and locate a pushbutton between two LEDS on a circuit board.

The red LED lights up briefly and turns off. Then the green LED lights up. This indicates that the receiver is in synchronisation mode.

2. Press the button of the desired channel on the remote control to be synchronised.

The receiver will store the code.

Wait for 30 seconds until the receiver emits two beeps, indicating that it has exited the synchronisation mode.

ATTENTION

If the procedure fails, it may mean that the receiver memory is full and impedes synchronisation of new devices. In this case only the installer will be able to synchronise any new remote controls.