SYNCHRONISING ERREKA ROLLING CODE REMOTE CONTROLS

Erreka remote control receivers enable remote synchronisation without handling the receiver or using the button on its circuit board.

ROLLER REMOTE CONTROLS

Remote synchronising procedure

1. Stand near the receiver, open the battery cover on the remote control already synchronised in the facility and press the button next to the battery or the synch button.

Release as soon as the LED on the receiver lights up

2. Press the button of the device to be synchronised.

The receiver will emit a beep to indicate that the remote control has been synchronised.

If the receiver fails to emit a beep it means that the procedure has failed, probably for the following reasons:

- The memory is full. The installer may have filled it on purpose. In this case, no devices can be synchronised without contacting the installer.

3. Wait for 30 seconds until the LED turns off, indicating that the receiver has exited synchronisation mode.

Direct synchronisation procedure on the receiver

1. Open the receiver and set the switch to the ON position.

The LED on the receiver will light up. From this point, follow the previous procedure from step 2 above.

SOL REMOTE CONTROLS

Both synchronisation procedures are identical to those for the ROLLER remote controls. The only difference is that a jumper must connect the first and fifth pins in the original remote control activate synchronisation mode in the receiver, and remove the jumper once this has been done.

This will not be necessary if synchronisation mode is activated from a synchronised remote control since the device is provided with a button for this purpose at the rear.