SYNCHRONISING KEY ROLLING CODE REMOTE CONTROLS

KEY remote controls can only be synchronised directly on the receiver.

Direct synchronisation procedure on the receiver (type A receiver)

1. Press button S on the receiver.

2. The LED (Ir1) will light up.

3. Release button S and press button P.

4. The LED (Ir1) will flash once.

5. Release the button.

6. Press the button of the remote control to be synchronised until the LED (Ir1) begins to flash, then release.

7. Wait for 10 seconds for the receiver to exit synchronisation mode.

Direct synchronisation procedure on the receiver (type B receiver)

1. Press KEY the same number of times as the channel you wish to synchronise (one time for channel 1, two times for channel 2, etc.).

2. The LED will flash the number of times equal to the number of the selected channel.

3. Within the next 7 seconds, press the button on the remote control to be synchronised for 2 seconds.4. The LED will flash once if synchronisation has been successful.

5. Repeat step 3 if you wish to add more remote controls.