HOW TO SYNCHRONISE SEAV ROLLING CODE REMOTE CONTROLS

Remote synchronisation procedure for SEAV remote controls

1. Stand near the receiver and press the first desired channel on the already synchronised (master) remote control for 15 seconds.

The receiver LED will begin to flash while it is waiting for transmission of a code.

2. Press the button for the same channel on the remote control to be synchronised (slave).

The receiver LED will light up steady, indicating that the channel has been synchronised.

Repeat the operation for the remaining channels.

Direct synchronisation procedure for SEAV remote controls

1. Open the receiver and press the button marked SEL.

The CODE CH1 LED will begin to flash while it is waiting for transmission of a code.

2. Press the button for the same channel on the remote control to be synchronised (slave).

The receiver LED will light up steady, indicating that the channel has been synchronised.

Repeat the same process for the second channel but pressing the SEL button twice (the CODE CH2 LED will flash) and pressing the second button on the slave device.

Observations

If the procedure fails, it may mean that the receiver memory is full, preventing synchronisation of new devices without the installer\'s permission.