HOW TO SYNCHRONISE STAGNOLI ROLLING CODE REMOTE CONTROLS

STAGNOLI remote control synchronisation can only be performed directly on the receiver itself.

Synchronising the remote control directly on the receiver:

During start-up, LED1 and LED2 will light up for two seconds as follows:

• LED1 on: Variable code programmed.

• LED2 on: Fixed code programmed.

• Both LEDs on: no transmitter in memory.

Once the receiver is powered up, press the synchronisation button (PG) a number of times corresponding to the operation you wish to complete, holding down the button on the last press.

Synchronisation of the first channel on the receiver: Press the synchronisation button (PG) twice and hold. LED1 will blink twice: press the transmitter button you wish to synchronise.

If the new code has been recognised and synchronised correctly, LED1 will emit a long flash.

By holding the synchronisation button (PG), it is possible to synchronise additional transmitters by pressing the buttons (one at a time) on the additional transmitters to be synchronised.

Synchronisation of the second channel on the receiver: Press the synchronisation button (PG) three times and hold. LED1 will blink three times: press the transmitter button you wish to synchronise.

If the new code has been recognised and synchronised correctly, LED1 will emit a long flash.

By holding the synchronisation button (PG), it is possible to synchronise additional transmitters by pressing the buttons (one at a time) on the additional transmitters to be synchronised.