Imprimir

You must enter each transmitter button separately. Depending on whether the transmitter / pilot button is to control channel 1 or 2, use the corresponding button on the radio card / control panel / receiver to enter the programming procedure:

1.Press and hold the \\"1\\" button on the radio card / control panel / receiver for 2 seconds (if theprogrammed transmitter / transmitter button is to operate channel 1) or the \\"2\\" button (if the programmable pilot / transmitter button is to operate channel 2). The LED will flash.

2.Within 20 seconds press the button of the transmitter / transmitter to be entered - the LED briefly illuminates with a continuous tone, indicating that the correct pilot / transmitter signal has been received.

3.To accept, press the \\"CLR\\" button on the radio / control panel / receiver or wait until the LED goesFor further buttons on this or other remote controllers / transmitters, proceed as per section 1-2-2 WARNING! - To edit the remote control / transmitter button configuration by deleting the channel assignment to the button, remove the remote control / transmitter from memory (point III), and then re-enter the buttons in the desired manner. Attempting to enter 16 remote control / transmitter will fail.

Synchronising the remote control directly on the receiver

It is possible to enter pilots / transmitters without having to access radio buttons / control panel / receiver. To do this, you must have a transmitter already in place, with the button configuration you want to get in the next (new) pilots / transmitters:

1.Press and hold any pre / programmed remote control / transmitter button for 20 seconds.

2.Within 20 seconds press any button on the transmitter / transmitter to be entered / programmed. In order to enter more transmitters, follow the instructions. point. 1 and 2

WARNING! - The procedure for simple entering pilots / transmitters adds a new remote control / transmitter and sets its buttons according to the pre-programmed transmitter / transmitter configuration used in this procedure.

For the simple procedure of entering the transmitter successfully, the distance between the transmitter / transmitter and the receiver / control panel should not exceed 20 meters.

Imprimir

DAR DE ALTA MANDOS EVOLUTIVOS SOMFY

El alta del mando SOMFY se puede memorizar únicamente de forma directa en el receptor externo y a distancia en el receptor de persiana integrado. Se debe diferenciar entre el mando SOMFY o TELIS.

Procedimiento de alta en el receptor

Receptor externo

1. Presionar el pulsador \"Prog\" en el receptor 2 segundos. El led rojo del receptor quedará encendido.

Receptor interno (Telis)

1. Presionar los botones arriba abajo del mando Telis durante 2 segundos. El led rojo del receptor quedará encendido.

Mando Keytis

2. Presionar el botón del mando a dar de alta. El led del receptor parpadeará.

3. Esperar a que se apague el led.

Mando Telis 1RTS

2. Pulsar medio segundo el botón trasero de altas del mando. El led del receptor parpadeará.

3. Esperar a que se apague el led.

Mando Telis 4 RTS

2. Pulsar el botón de selección de canal hasta que el led del canal deseado se encienda.

3. Pulsar medio segundo el botón trasero de altas del mando. El led del receptor parpadeará.

4. Esperar a que se apague el led.